Electronics Forum | Fri Jan 06 17:20:47 EST 2006 | davef
Mike You get what you ask for. We ask for 0.001 inch minimum. If your supplier's published process range allows thickness below 0.001 inch minimum, you need to define your own acceptance criterion. We don't use average measurements in lot inspect
Electronics Forum | Wed Jan 23 13:48:06 EST 2008 | flipit
You can do a destructive test to sort of check your process. Break off the flipchip and look for voids. I have used Namics 8437-2 for the last 7 or 8 years. Good stuff. Flows under a 0.001" gap with no voids. Chris
Electronics Forum | Fri Apr 25 13:30:45 EDT 2008 | flipit
I use Namics 8437-2 for micro BGA and flip chips. Will work for QFN or MLF after soldering. Flows well under gaps as thin as 0.001". Cure in 5-10 min at 150 C. Rock solid product. Is bit expensive. Is from Japan.
Electronics Forum | Tue Nov 25 15:56:05 EST 2008 | mikesewell
It read to .0001 and was repeatable to +/- .0005. As the SR coating got thicker, it was more sensitive to pressure since the transducer (ours was a 1/8" dia.) would press into the coating. You might request a demo from a vendor and see if it is a f
Electronics Forum | Wed Sep 23 13:00:08 EDT 2020 | rsatmech
Hi Ameen, As I said before my defect rate is 0.001% and i am planning to reduce the stencil opening only. Will share the result once I implement it. Expected to complete it withing next week. Thank you.
Electronics Forum | Fri Sep 17 03:46:31 EDT 1999 | Charles Stringer
| | I am not familiar with the "mil" metric. How many inches is in 1 mil? | | | | ...or 10 mil? | | | | | each mil = .001" | | Earl Moon | At risk of informing someones grandmother on the art of removing the contents of an egg without breaking
Electronics Forum | Tue Nov 04 17:08:04 EST 2003 | davef
We have this in our hydrometer use notes. We assume it's from our hydrometer supplier. Temperature Correction All hydrometer readings must be corrected from the temperature they were read at, to the temperature the hydrometer was designed for. Mo
Electronics Forum | Thu Aug 29 11:56:21 EDT 2013 | kdc45
Sent program to a CP43 and the part data was not recognized. Machine message to power down and back up, so we did so. On power up, screen appeared with the following: OS Error Err Code 0001 Err task 0028 Err para FFFF Ex stat 0151 Err adrs CC400000
Electronics Forum | Thu Aug 30 15:38:09 EDT 2001 | allie
I need a good chuck, new or used, for a QUAD 100 pick and place. The chuck size is 00-001XG. The one I have has worn fingers, bushings, and leaks air around the nozzle. How difficult are these to rebuild properly? I would appreciate hearing from a
Electronics Forum | Mon Aug 04 17:35:08 EDT 2003 | Dean
If you lay a flat edge on the PBGA, it is visibly warped? How much of a warp? 0.001, 0.010, 0.050 what? What is your pcb temperature just prior to entering the spike process (zone or step or what ever you call it)? Is it between 165 and 175 C?