Electronics Forum | Tue Jul 02 10:57:29 EDT 2019 | BigFuji642
Are the pinouts for the cable mirrored (like normal Male to Female DB pinouts)? Like the Male pins when looking straight at them are 1 2 3 4 5 and the female when looking straight at it is 5 4 3 2 1 Or is it that they are not mirrored and both ar
Electronics Forum | Thu Oct 22 03:10:49 EDT 2015 | myleb
I already check that sir, maybe its a loose > connection or board problem. maybe the ssr board was damaged. try swap the ssr between the A and B stage. Open the machine cover at AF/BF stage, it's the down left board with many connectors (have COV1
Electronics Forum | Fri Sep 24 19:17:36 EDT 1999 | Tom Tellinghuisen
Al, There are no 'rules of thumb' that you can utilize for plastic devices. I have seen various Moisture Sensitivity Levels, (MSLs), for the same package type, i.e. PLCC28s as levels 1, 2,3,4,5, even 6 in some cases. Your best bet is to call
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Sat Dec 17 16:46:45 EST 2011 | eadthem
Startup current depends on your configuration. ours dose zones 1,2/ 3,4/ 5/ 6,7 last i checked it pulled about 40-55 ish on start up and 25-35 during run. our profile is a slow ramp till 170c then a fast ramp to 285c 280c(last 2 zones). 1707's
Electronics Forum | Wed Sep 30 10:38:42 EDT 1998 | Earl Moon
| Anyone have ideas how to get MIL 50884 Qualification?. | | We are a small/mid sized Flex, rigid-flex circuit shop in Canada considering MIL Qualification. Is there any web site that we could check out? | | any advice is appreciated. | thank
Electronics Forum | Wed Jun 11 11:12:10 EDT 2003 | JB
We rarely use the tack-time on our machines, even if we run products that are populated with large components. ( ICS, Tant caps etc.) There is a default tacktime for each component on the component library, is called Speed Data. For the components
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
