Electronics Forum | Fri Feb 14 17:42:11 EST 2003 | dgjjr
I would agree on keeping the gaps to a minimum but make sure you have enough maintenance access to the pick and place and oven. Pulling a conveyor out with an 1/8th on either side is no fun. Same goes for bolting to the floor, make sure you can unb
Electronics Forum | Tue Nov 25 05:40:52 EST 2008 | wanderson
Calibration menu and then Index Cam Setup and follow the on screen instructions. (You can skip the focus step if you have not adjusted the camera's) The point you need to pay particular attention to is when it displays the intensity histogram, this
Electronics Forum | Thu Jun 17 10:22:51 EDT 2010 | floydf
Last July I posted a query about reflowing leaded paste to gold plated boards, I wasn't getting a good reflow. The answer that seemed to work was dwelling the board at reflow for the maximum recommended amount of time. Would anyone have an opinion on
Electronics Forum | Thu Jun 17 12:32:25 EDT 2010 | floydf
Last July I posted a query about reflowing leaded > paste to gold plated boards, I wasn't getting a > good reflow. The answer that seemed to work was > dwelling the board at reflow for the maximum > recommended amount of time. Would anyone have a
1 |