Electronics Forum | Tue Nov 30 21:23:55 EST 1999 | cklau
hello; When we are doing component land pattern design , one thing will always be in our mind; that is the basic criteria or common land pattern design guideline for reflow and flow solder assemblies. For basic fomula in calculating resistors are:
Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley
Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are
Electronics Forum | Mon Apr 23 11:44:55 EDT 2001 | CAL
650 Standards are also located in the back of IPC JSTD-001. I am currently looking at 4 pages on bow and twist. Percent bow = R1-R2/L x 100 (R1= Highest point; R2=lowest or resting point; l= length) Percent twist=(R1-R2)/(2xL)x 100 Sorry if this is
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Mon Jul 31 16:33:48 EDT 2006 | G.P.
I think he meant stencils where the print pattern is front, left, or right justified on the stencil itself as opposed to being centerred. Is that what you meant. It can be done on DEK printers, but it has been several years that I worked with an MP
| 1 |
