Electronics Forum | Tue Aug 31 12:53:15 EDT 1999 | jseagle
Just what the subject says. If you are what type of machine are you using, is it mechanical or vision centered? What is the reject rate? Thanks for any help. James
Electronics Forum | Sat Sep 05 23:15:32 EDT 2009 | prasadz
We have successfully implemented this dual Process You can use any printer that supports Board width 500mm. SMT Dual Process Maximum PCB Width should be (500-20 / 2 ) = 240mm Max (PCB width )Printer support = 500mm Top width + Bottom width
Electronics Forum | Fri Mar 22 17:14:15 EST 2002 | jseagle
What is the height, width, and length of the connector, packaging? We currently place a 2x20 2mm gull wing SMT connector measuring 8mm H x 38mm L x 6.1mm W, packaged on tape and reel with a plastic pickup in the center. We do this on an Assembleon
Electronics Forum | Fri Apr 30 10:39:15 EDT 2004 | Bryan She
I found much ICT fails on the same location(Ref.des:Q166) on my boards. 1.Defects rate:more than 20%. 2.We measured the value of the transistor before reflow oven,it's ok.but measure again after been reflowed,result is fail.it seems fails happen duri
| 1 |
