Electronics Forum | Fri Jan 26 11:24:32 EST 2007 | aj
I would have to agree with you Greg, I suppose Longterm will tell. aj...
Electronics Forum | Mon May 20 09:24:32 EDT 2013 | davef
SAC / Ni interface is the IMC (Cu, Ni)6Sn5
Electronics Forum | Fri Feb 22 18:24:32 EST 2019 | dekhead
Really need answers to all questions.
Electronics Forum | Mon Jan 15 08:24:32 EST 2001 | adrian
I thought the stencil was flush to the top of the board when Screen printing. When does this snap off occur in the screen printing process?
Electronics Forum | Wed Mar 06 10:24:32 EST 2002 | Charlie
Here our senerio: * There are no funds for additional test equipment. * Have only Delta Scan results, that are very limited. * Failuer of Delta Scan, PCB goes to vendor for X-ray analysis. Do you have a similar process and do you do anything diffe
Electronics Forum | Tue Jan 28 18:24:32 EST 2003 | rob_thomas
Hi James, It's been done and tested and at my previous job.The solder joints life expectancy is the same as for PBGA's attached to rigid substrates. If you want more details and process specific details send me an e-mail at the above address. Good l
Electronics Forum | Wed Oct 13 16:24:32 EDT 2004 | shane beard
Every BGA that I have mounted has some degree of scaling in the solder joints. Is this due to a lack of peak temp? Anyone out there have any ideas?
Electronics Forum | Wed Mar 14 11:24:32 EDT 2007 | Scotceltic
Have you thought about switching to either automatic paste dispensers or rhemoetric pumpheads in order to contain the paste and only dispense what is needed during your shift ? I am not sure what type of printers you have, but I know both of these o
Electronics Forum | Thu Nov 28 20:38:17 EST 2013 | daiichid1hk
our company can offer some siemens feeder for sales. Siemens 3*8 Gold Siemens 3*8 SL Siemens 12/16mm 24/32mm 44mm 56mm 72mm 88mm Siemens 2*8 Hover Davis 3*8mm
Electronics Forum | Sat Feb 12 10:24:32 EST 2022 | compit
Maybe the pin (?) with wheels on the ends of the belt bent? Can they be rotated 180 degrees?