Electronics Forum | Tue Jun 25 18:28:32 EDT 2002 | genny
What about a twist tie? Reusable.
Electronics Forum | Thu Apr 20 17:28:32 EDT 2006 | GS
The simple way should be to wire the ground according to your National Safety Standards. Regards........GS
Electronics Forum | Mon Mar 08 08:28:32 EST 2004 | pjc
New Stencil Cleaning machine on the scene. Saw it at APEX 04, manufactured in West Viginia. http://www.pressureproducts.com/SPPC_Hm.htm
Electronics Forum | Tue Dec 07 20:28:32 EST 2004 | jjwhite
Why can't I access some of the messages found with searches? Ex: search for "Chain lubrication" has 9 results. Only the last 4 (in 2002) appear even though I click on newer ones. This is not the only search that produced these types of weird things.
Electronics Forum | Sun Jul 31 23:28:32 EDT 2005 | saiwong
Fuji will not sell the reel by itself. also, you need to change the tape guide to 0.7 in order to place the 0402. Tape guide cost you almost a hundred bucks. I don't think it is a good idea to modify the feeder.
Electronics Forum | Wed May 02 11:28:32 EDT 2007 | Scotceltic
Might seem too simple but make sure your fids are defined and locking on correctly. Also, run frequent center checks on your nozzles.
Electronics Forum | Thu Oct 29 07:28:32 EDT 2015 | prameel_84
Request you to spell out the key points to be considered for purchasing Ionic Contamination Tester
Electronics Forum | Mon Nov 11 11:28:32 EST 2002 | davef
Sand is not a great conductor, compared to copper. Never heard of using the stuff on RF boards. Our board fabricator uses Dupont CP100, now CP101, [or something like that cuse who's going to check?] when plugging via on cheap boards. Your board fa
Electronics Forum | Fri Oct 29 05:28:32 EDT 2004 | dj_jago
I think you would be better off designing routing slots into your panel and then use a high speed router to cut out the PCBs. PMJ Automec/Cencorp make such equipment (I used to work for them) but have no affiliation to them anymore. Alot of peopl
Electronics Forum | Wed Apr 14 14:28:32 EDT 2021 | lpbro
My first move is inspect the blades, swap the blades around and re-balance the blades to see if it is a problem that corresponds with a specific blade. Also try a different pair of blades. Full restart on the printer incase of an odd software problem