Electronics Forum | Wed Oct 17 09:13:50 EDT 2012 | sfeinsp
How to turn OFF message "Solder Insp OFF" on Mirtec 4.5.5.0 program
Electronics Forum | Mon Mar 13 10:03:34 EDT 2017 | oxygensmd
Depends on where are you located? If you are from EU, I can recommend a 4-5 manufacturer.
Electronics Forum | Mon Jan 22 14:22:46 EST 2007 | muse95
Actually, I've been looking into this myself, and the B version doesn't help any more than the A version. The tables still only go to 4.5mm. And Appendix B has a bunch of formulas with undefined variables that I haven't been able to figure out. An
Electronics Forum | Tue Jul 02 10:57:29 EDT 2019 | BigFuji642
Are the pinouts for the cable mirrored (like normal Male to Female DB pinouts)? Like the Male pins when looking straight at them are 1 2 3 4 5 and the female when looking straight at it is 5 4 3 2 1 Or is it that they are not mirrored and both ar
Electronics Forum | Mon Jan 30 22:45:30 EST 2017 | cmarasigan
Hello Marc, Thank you for the recommendation. I've contacted our local service support. We found out that heat coming from higher zones 7, 8 & 9 overflows to zone 3, 4 & 5 which affects actual temp reading at Z3,4,5. Since we already replaced some b
Electronics Forum | Thu Sep 16 17:56:48 EDT 2010 | asksmt
Ok Thanks, i have reduced thermal pad size by 4.5 mils on top and bottom part of this footprint where the problem was occuring, so now the clearance between thermal pad and lead pads are 12 mils instead of 7.5 mils on two sides. (i kept the signal pa
Electronics Forum | Fri Apr 17 12:09:21 EDT 2015 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
Electronics Forum | Wed Jan 31 11:53:39 EST 2001 | rocky1
Looking for another source beside Omega! We buy the Omega brand 5SC-TT-K-36-36. Omega's lead-time on this stuff is 4-5 weeks. Can anyone help?
Electronics Forum | Thu Sep 16 03:53:04 EDT 1999 | park kyung sam
Can you imagine that there is a smt process using the a few chip and ic are nearly about 4,5,6,8 years old. Antigues?? what should you do If you are an engineer of smt process in that company. thank in advance.
Electronics Forum | Wed Mar 26 15:46:43 EST 2003 | Ren�
To remove or Place a BGA in a BGA reworks machine , do I have to do a same profile as a normal Oven ( around 4.5 mins to Peak time ) or the conditions are only to get temperature needed to Solder or Remove ( no matters Time).
.gif)
