Electronics Forum | Mon Mar 05 22:31:43 EST 2012 | acsscott
Using the 72A FNC nozzles to place 3216 resistors, and 74F nozzles to place PLCC6 LED's. The LED's ar 5mm x 6.5mm x 2.4mm tall.
Electronics Forum | Mon Jul 26 14:16:54 EDT 2010 | jdengler
I don't find this P/N in my list of 2.5mm IP2 nozzles. But we buy from and have bad nozzles repaired by SMT Researh. www.smtresearch.com Jerry
Electronics Forum | Mon Aug 21 10:47:48 EDT 2006 | FredC
Hello Mika, I just checked a windmill and a test nozzle we have on the bench. The useful travel of the nozzle before the risk of the crosspin getting stuck in the loading gate is 1.5mm, if it gets stuck it is the nozzle is 1.7 up. If the cross pin is
Electronics Forum | Fri Feb 01 05:42:21 EST 2008 | aj
Hi all, Is anyone out there placing 0402 with a CP4? Not sure how reliable it would be and also how do work around the nozzle setup ? we currently have 2.5mm ,1.3mm & 1.0mm so do you remove say 6 x 2.5mm and put in 0.7mm. Any replies appreciated.
Electronics Forum | Thu Apr 05 16:28:35 EDT 2012 | acsscott
I have told the Topaz that it has 73 nozzles installed, and selected to use 73 nozzles for the LED's. THe 74 nozzles are actually on the machine. I think it has something to do with the part dimensions in the vision section. The part is 5mm x 6mm
Electronics Forum | Mon May 02 18:40:50 EDT 2005 | russ
I don't know what machine type you have or what the nozzles look like but we use a standard nozzle with an I.D. of either .8 or 1.5mm. We rotate and pick up the part somewhat slowly.
Electronics Forum | Fri Sep 06 13:49:17 EDT 2002 | soupatech
Question: I am going to start placing 3mm x 3mm plastic smt leds and want the absolute lowest errors caused by the nozzle either dropping or allowing the part to shift. Would a 2.5mm nozzle be too big for the 3mm part. My logic is that the more surfa
Electronics Forum | Tue Feb 10 05:58:14 EST 2015 | dberenguer
We have the possibility to buy a used Zevatech FS710 pick&place machine with vision. I've read that these machines used to be very well built but I'm wondering if it's capable to place 0603 parts accurately since it lacks a laser-type alignment AFAIK
Electronics Forum | Fri Apr 15 11:52:09 EDT 2005 | vikkaraja
Part is being pre rotated already and I also changed the nozzle size from 15mm to 17.5mm this morning. There is no board warpage at all and production is watching for it while an operator puts on a barcode label.
Electronics Forum | Fri Aug 10 13:52:58 EDT 2001 | davef
When you say that glue viscosity changes for lot to lot, is this LOT TO LOT of your product OR Loctite�s product? And when you say that glue viscosity changes, what do you mean [eg, increase by � , decrease by � , er watt?]. What specifically is th
