Electronics Forum | Fri Sep 02 09:10:20 EDT 2016 | ttheis
Probably similar cost to find one on ebay or a used machine broker vs. repair unless the fault is obvious from visual inspection. I would be interested to know if anyone does service cards from these older VME chassis though.
Electronics Forum | Wed Aug 31 17:23:00 EDT 2016 | corepride
Hi everyone, I have a problem with the 630 VME vision system: during startup machine, an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want to continu
Electronics Forum | Mon Apr 11 08:47:34 EDT 2005 | Rob
There's not many ways of doing it on the cheap except... Buy a second hand universal GSM1 with VME 630 vision, 0.5 mil per pixel camera & some expensive ceramic nozzles for the 0201's. This will be quite slow & the software quite awkward but lookin
Electronics Forum | Sat Mar 02 18:02:26 EST 2013 | dilogic
Which vision does your machine have? I guess it is Lantern 630 or 640? Is there any text in the vision window after boot? regards Dejan
Electronics Forum | Mon Mar 04 19:05:44 EST 2013 | jaimebc
Deni, it is a 630 and there is text in the window, just no image of the component or anything else that is brought to the camera. It doesn't time out at all, it just moves the way it would when inspecting a component on test mode.
Electronics Forum | Tue Nov 24 10:22:22 EST 2015 | ttheis
I checked and it is 630vme. I'll check input line filters as mentioned in next post.
Electronics Forum | Sat May 07 15:49:19 EDT 2005 | marcelll
Need a wiring info from somebody who have the schematics for a GSM running the old vision system AIM 3500. There's 2 cables plugging in the vision box, "vision DigA" & "vision DigB" with DB15 connector. I need the pin out of these 2 cables to con
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Mon Nov 23 13:46:14 EST 2015 | dilogic
It is written on power-up screen after booting USOS (green letters). I am attaching image of mine, but with newer VME630 vision. If yours shows AIS3500 there, it is probably a problem with video DAC inside that box (located on the machine rear end, a
| 1 |
