Electronics Forum | Sun Jul 09 03:05:14 EDT 2000 | Ben
Hi Hermie, Did you perform a Servo-zero-adjustment and Gain calibration on the amplifier after replaced it ? This is necessary fine turning when replacing the amplifier. You had better ask Fuji service center for the procedure. Hope this help you.
Electronics Forum | Thu May 27 15:59:30 EDT 2010 | mikesewell
ATS-667 tape. You can buy direct http://www.ats24.com/index.cfm?fuseaction=content.display&contentid=50 or through distribution such as All-Spec. Polyester film with rubber resin adhesive (no silicone) = clean mask lines. Call for a sample.
Electronics Forum | Thu Dec 18 10:12:47 EST 2014 | capse
I represent Epoxy Technology. They supply both epoxies and ployimides for this application. You reach their Applications Support group at (978) 667-3805. If you are located in the southeast you can also contact me.
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Fri Jul 07 13:39:53 EDT 2000 | pr
I know you're not gonna buy this one... But we had the same thing and it was the metal sleeve covering the ball screw. Spray some Biral on it to loosen it up. I didn't believe it but we did it and instantly the problem went away (2 times on 2 differe
Electronics Forum | Thu Jan 03 17:30:27 EST 2008 | davef
Consider conductive epoxy. Among the suppliers that make the stuff are: * Master Bond [154 Hobart St, Hackensack, NJ 07601; 201-343-8983 F201-343-2132 http://www.masterbond.com] * Chomerics [Parker Hannifin, 77 Dragon Ct, Woburn, MA 01801; 781-935-4
Electronics Forum | Mon Jul 21 09:34:54 EDT 2003 | caldon
A machine for serious concideration MRSI 175uf Features: -High-throughput Underfill -Parallel Processing Conveyor Lanes -Linear Positive Displacement Pump -Total Process Thermal Control -Intuitive Graphical User Interface - Windows NT -Advanced
Electronics Forum | Sun Oct 27 10:22:43 EDT 2013 | davef
UV Nd:YAG Laser--> Excimer Laser: An increase in system capabilities & ablation quality * CO2 Laser-->UV Nd:YAG Laser--> Excimer Laser: A decrease in processing speed and relative increase in manufacturing cost Laser ablation equipment suppliers: *
Electronics Forum | Tue Jul 25 16:08:52 EDT 2017 | dontfeedphils
I'm currently working on bringing a manual coating process/workcenter online and my QA team is giving me some grief. For background, we're using Humiseal 1B31 thinned with thinner 521, mixed at 1:1 by volume. Spraying through a Binks HVLP with 10 P
Electronics Forum | Wed Dec 02 09:00:23 EST 1998 | Dave F
| I am interested in inspection machines working with comparation, the results that I need for inspections are missing parts, component offset, polarized components, etc. The machine can work in line or off line. | | Thanks for help. Sergio. | Serg