Electronics Forum | Wed Feb 26 18:48:01 EST 2003 | kennyg
I'm trying to solder a 0.011" lead into a 0.015" +/-0.003" hole. Stop laughing please. This is normally possible with difficulty, except if the lead is removed and the attempt is made to re-install a lead. Anyone have thoughts on how to remove nea
Electronics Forum | Mon Nov 16 20:22:52 EST 2015 | billthebuilder
I need one for testing a PnP machine. It's very hard to hunt something down just by package, so does anyone know of anything with a 0.3mm pitch? BGA preferred. Or clues where to look? Thanks!
Electronics Forum | Tue Nov 17 17:05:50 EST 2015 | davef
Look here: http://www.topline.tv/Pitch.html We receive no benefit from posting the link above.
Electronics Forum | Tue Nov 17 19:27:53 EST 2015 | billthebuilder
Thanks for your response. I have already been trading emails with them but their minimum order quantity is too high for me unfortunately.
Electronics Forum | Wed Nov 18 12:56:40 EST 2015 | dyoungquist
Try http://www.practicalcomponents.com/ They have lots of dummy parts and may have what you need.
Electronics Forum | Mon Dec 27 13:34:28 EST 2010 | ppcbs
Does anyone have any experience in printing solder paste on a 0.0065" pad? I have a requirement to attach single chips with 600 to 2400 connections. The chip has a 0.005" solder ball, 0.010 pitch. Attaching to a substrate with a 0.0065" pad. An
Electronics Forum | Tue Jun 07 16:25:29 EDT 2005 | davef
We use a 0.012 inch gap betweem 0402 pads.
Electronics Forum | Fri Apr 06 10:43:57 EDT 2007 | flipit
Hi, Anyone seeing difficulty is soldering MLFs or QFN with lead free solder? I have an MLF with 3 rows of pads on each of the 4 sides of the part and then the large center ground plane in the middle. The part is 20 mil pitch. Had good luck with l
Electronics Forum | Wed Aug 20 21:30:56 EDT 2003 | paulm
Our company if currently reviewing our BGA Screen Printing Process. The problem we are trying to eliminate has to do with BGA Ball Size Variance. Some of our vendors are allowing a +/- of 0.004" in ball size. This would allow for the possibility of a
Electronics Forum | Fri Oct 10 17:27:10 EDT 2008 | wagoner
We have several similar parts in our factory and they usually don't give me any problem. One part has a 0.050 pin that goes into a 0.055 hole, and we place it with Panasonic MSR turret style chip shooter, which has a placement accuracy of only +/- 0