Electronics Forum | Mon Mar 20 11:48:21 EST 2006 | Chunks
jdengler may be right. Had a 10 zone do the same thing. It was a couple links in the chain.
Electronics Forum | Tue May 04 11:34:06 EDT 1999 | Ken Pishko
Need a footpint for a 10 lead uSOIC (RM-10)
Electronics Forum | Mon Feb 03 16:30:47 EST 2020 | dontfeedphils
Reason I ask is because I've never really paid much attention to the cooling rate, but I'm currently running a 10 zone oven and using all 10 zones for heating whereas I've almost always used a 10 zone as 9 heating and the last as a cooling. I'm curr
Electronics Forum | Mon May 10 17:18:27 EDT 2010 | hegemon
Could you be looking for an endoscope with a 10 mil O.D? Not aware of anything that small. Am I reading you correctly? You are trying to peer into a 5 or 10 mil opening to see what's happenning inside of something? 'hege
Electronics Forum | Mon Sep 18 14:43:06 EDT 2006 | jdengler
Steve, I don't think it was a Yageo if the value is 10 ohms. Yageo would label them as 10R0 for 10 ohms. 1002 would be a 10K ohm resistor. Jerry
Electronics Forum | Fri Jan 12 09:17:36 EST 2001 | Dave F
Mir is getting set-up to do a 10 point full gainer with a twist into the Pacific Ocean sometime in Febuary. So, this is your last chance to check it out in the night skies. As they say as you exit the plane ... bahbeye
Electronics Forum | Tue Feb 13 09:14:07 EST 2007 | nitro
I agree with JAX. We run four Omniflow 7 ovens for leaded and lead free products. The process window is tighter with these than that of a 10 zone oven. It takes a little more time and work to get the profile dialed in with less zones.
Electronics Forum | Tue May 13 15:48:43 EDT 2008 | mmjm_1099
Well I figured it out. The XP242 vision system is STUPID. I had to use a vision 18 instead of a 10 because it was seeing a leg.
Electronics Forum | Thu Dec 13 16:18:29 EST 2001 | smtspecialist
I have a 10k thermistor to solder to a board, the problem is that the thermistor can't absorbe more then 105 degree C and as soon as I send it through the reflow oven or hand solder it, the part internaly over heat giving inconsistent readings. Any
Electronics Forum | Mon Aug 02 09:49:12 EDT 2010 | vetteboy86
My problem is that a 10k 0805 chip looks fine next to a 100k 0805 that is brown.