Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Thu May 22 16:16:05 EDT 2008 | rmitchell
Hi, Our MY19 will not advance our slot 2 feeder in all tape and reel LM magazines. Other slots advance fine on the same magazine but #2 will not, no matter where we position the magazine along the machine. Any info-
Electronics Forum | Wed Aug 27 19:06:49 EDT 2008 | joojoo
I am looking for an advance level soldering hands-on skill training to do rework on SMT and BGA replacement in the San jose area, California. If you know any training school in the area, please email me directly,thanks. noorkota@hotmail.com
Electronics Forum | Tue May 27 13:27:38 EDT 2008 | tech1
Sounds like you got something stuck in the magazine bus and it blew the circuit in that lane. I think you can swap out chips on one of the computer boards in the system.
Electronics Forum | Thu May 29 12:14:57 EDT 2008 | bsumfg
Hi, I'm confused by your post. Are you saying one of your magazines does not work in the 2nd feeder postiion even if you move the magazine to a new slot on the machine or are you saying all your magazines do not work in the 2nd feeder position reagr
Electronics Forum | Wed Aug 27 22:48:59 EDT 2008 | davef
Try: * SMT Plus; 14178 Pepperwood Dr, Penn Valley, CA 95946; 530.432.3806 F530.432.8746 http://www.smtplus.com sales@smtplus.com * STM Service To Mankind; Training Center, 4065 Clipper Ct, Fremont, CA 94538; 408-274-7119 http://www.stmtraining.com i
Electronics Forum | Wed Jun 04 00:28:27 EDT 2008 | chrispy1963
There are a couple of things that you can do. First thing to do is take a flashlight and shine it in the card edge connector of slot 2 and see if a passive component or any other part worked its way into that slot. This will cause multiple leads in
Electronics Forum | Fri Feb 22 12:09:51 EST 2008 | mainenetservices
Hi Steve, We have added location as part of the advanced equipment search. Roland
Electronics Forum | Wed May 08 10:05:42 EDT 2002 | Claude_Couture
Maybe the problem is not the cutter, but the arm that advance the tape in the adjacent feeder gets actuated at the same time as the active feeder. line-up a feeder in pickup position visually, then turn the crank until the roller or feeder advance me
Electronics Forum | Tue Sep 27 15:58:01 EDT 2011 | ck_the_flip
We use exclusively pneumatic feeders and can NOT control the force or speed of advancement. We get a lot of components (mostly LED-type packages) that tend to flop around in the pocket a lot and are flipped on the side or “thrown” by the feeder duri
