Electronics Forum | Mon May 12 23:33:48 EDT 2003 | dehlers
I purchased three On-Site units a while back to feed two reflow ovens and one wave solder machine. The cost for the lot was approx. $160,000, and flow was approx. 7500 CFH. We were quit pleased wqith the performance and the operating cost. However
Electronics Forum | Sat Oct 28 10:24:56 EDT 2000 | Ben
Try to insert thin copper plate (approx. 1.5mm thk) at the end of the flow direction. Place it approx. 2mm away from the lead. The copper will pull away the solder & thus minimise bridging problem.
Electronics Forum | Mon Oct 30 18:29:56 EST 2006 | SWAG
We are done with our experiment - approx. 25% of the boards we sent through this test showed delamination.
Electronics Forum | Fri Jul 17 05:09:10 EDT 2020 | sara_pcb
I have identified one equipment "MALCOM SWB2 " What is the approx budget required
Electronics Forum | Mon Aug 29 11:47:25 EDT 2005 | stalkerb
Do you have expierience of this type of Machine. approx how many product types are you running on your wave/ersa...? and approx batch sizes We have had a 5060 for about 1 year and it has been a revalation. your input is appreciatted as i am consi
Electronics Forum | Wed Sep 07 04:58:59 EDT 2005 | Rob
If by singulation you mean depanelising then the following: Press with steel rule die & plate - approx $500 for tooling Not particularly accurate, and needs replacing regularly, can be modified very easily Press with die tool - approx $10k-20K too
Electronics Forum | Thu Sep 29 13:39:08 EDT 2005 | PWH
Universal GSM1/2 go W18.000� x L20.000� depending on configuration. I have done boards as much as 22" long with some creativity. GSM1 runs about 4500 pph (approx. 2500 pph realistic) and GSM2 9000 pph (approx. 4000-5000 pph realistic). Cost used fo
Electronics Forum | Wed Aug 23 08:08:25 EDT 2006 | aj
There are a few variables that you have to consider : 1. Hours available on Wave Machine ( are other products going thru the same wave) 2. What beat rate are the boards being supplied from previous station?i.e. do you envisage the waveto be a bottl
Electronics Forum | Fri Dec 09 08:24:48 EST 2005 | zanolli
Dear Technetters We have a unique soldering operation that needs automation and we will be evaluating various methods including laser reflow and Spirig�s Microflame. The actual soldering operation entails joing two metal contacts by depositing a sol
Electronics Forum | Tue Mar 13 09:09:23 EDT 2007 | cyber_wolf
We have been asked to provide the OEE on our SMT lines. Any examples of OEE reports that I have looked seem to be from OEM or high volume production lines. Our SMT area is high mix - high changeover. We also run prototypes and start-ups through the