Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Tue Jun 14 16:23:22 EDT 2022 | glasscake
Cant put a finger on it being an encoder that was just a single possibility. You can always hook up a scope to the encoder and see if they are working appropriately. I would look through the machine's utilities and see if there is some debug or more
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Mon Apr 16 10:48:58 EDT 2012 | cyber_wolf
Sounds like a bad or out of adjustment servo amp.....
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Mon Jul 08 13:49:10 EDT 2002 | msjohnston
HI, We are looking into expanding our current x-ray inspection from manually inspection one panel per lot to 100% automated inspection for all of our BGA and CSP builds. We have 100% manual inspection at the end of our SMT lines and we are consideri
