Electronics Forum: bedtime (4)

Gold plated PCB's

Electronics Forum | Fri May 03 19:02:41 EDT 2002 | davef

Several of the points you make are reinforced in the fine SMTnet Archives. Consider searching them for bedtime reading, until the responses start flowing.

Re: wave solder

Electronics Forum | Tue Jun 13 12:03:10 EDT 2000 | Chris May

Jason, If 225C is the topside temp of your board just prior to hitting the wave, I would say this is too high. Your flux suppliers data sheet should tell you an ideal topside temp for good flux activation, probably around 190C. According to the Bi


bedtime searches for Companies, Equipment, Machines, Suppliers & Information

Sm t net
  1