452 block results

Electronics Forum: block (Page 1 of 46)

block function for topaz

Electronics Forum | Wed Oct 01 01:15:35 EDT 2008 | benefon

If you have your panel programmed as blocks (as opposed to expanded) two quick ways come to mind: 1. either use block badmarks to mark those blocks that you want to skip or 2. goto Block Repeat Info and mark and set the block that you want to skip as

block function for topaz

Electronics Forum | Wed Oct 01 15:20:39 EDT 2008 | slthomas

1) Is it possible that there is another program for the board w/o without the block conversion? Renaming instead of copying the file to a new name is one mistake I won't make again! 2) Are there "notes" in the last column of the placement data? If t

block function for topaz

Electronics Forum | Tue Sep 30 19:48:14 EDT 2008 | snsmt

I have a block programmed and i want the machine to just do one block at a time instead of doing the whole panel (each panel has 56 PCBs) at once and skipping around. how would i do that? thanks in advance steven

block function for topaz

Electronics Forum | Wed Oct 01 18:48:19 EDT 2008 | snsmt

i got it!! thanks everyone

Placing components by board instead of per block (Assembleon)

Electronics Forum | Wed May 20 14:07:23 EDT 2020 | joost

My Assembleon Emerald Xii runs its production block by block instead of board by board, this causes a lot of nozzle switches. If you have a board with 6 blocks present, is it possible to finish all the mounts on all blocks of a certain component bef

Placing components by board instead of per block (Assembleon)

Electronics Forum | Mon Jun 08 09:20:57 EDT 2020 | vinitverma

Since it is an Emerald XII, I suppose it is Windows and not VIOS. Go to Optimize and select "Convert with Note Data". This will convert all blocks to single PCB and keep a NOTE of original Block Data so that you can convert back to block if and when