Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Mon Dec 29 09:10:22 EST 2008 | stepheniii
It takes time for the moisture to penetrate into the body. I think the 5 years of ambient would be more the culprit than washing the boards. Especially since you are baking them after wash. Get a few of the ICs and put them loose on a board and put
Electronics Forum | Wed Feb 01 12:57:51 EST 2006 | wheels_in_the_well
There are several makes of stencil cleaning equipment. The previous post mentioned, Aqueous Tech (www.aqueoustech.com). Others of long standing high reputation are EMC Global (www.emcgti.com), Austin American Technology (www.aat-corp.com), and Tech
Electronics Forum | Wed Feb 01 12:20:16 EST 2006 | cvoyles
Hi Bruno, I am an equipment reseller in business since 1994. I have a Smart Sonic MG3000 ultra sonic stencil cleaner in inventory. It is a stainless steel model with Delta Sonics brand ultra sonic generator. It is the guillotine type that raises a
Electronics Forum | Wed Feb 01 13:46:05 EST 2006 | Chunks
Sounds like a epididymis! It depends on your paste chemistry. You can't just slap any old saponifier in there. Most water based cleaners evaporate the water and you have to remove the dried paste. It's a bit messy, maybe that's why your's is over
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Dec 03 15:38:35 EST 2015 | ttheis
Thanks for the tip! Do you find the boards require any cleanup after exiting the wave with the Superior 420-XF-LF?
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Wed May 30 12:40:22 EDT 2018 | davef
Drink the Absolut IPC published the Stencil and Misprinted Board Cleaning Handbook (IPC-7526). Free download here: http://shop.ipc.org/IPC-7526-English-D
Electronics Forum | Tue Oct 09 11:22:08 EDT 2001 | nifhail
Can I use one common cleaning agent to clean the stencils from a lines which are using RMA, No-clean and clean paste ( b'cos we onlyhv one stencil cleaner ). What about those misprinted board ? Can all of them use the same chemical or cleaned in the
.gif)
