Electronics Forum | Mon Aug 27 12:33:46 EDT 2007 | emilio1
Hello everyone; I was wondering if anyone has/knows where to get, VIP98 FCU calibration procedure. I know its a long shot but need to calibrate a few ovens and we�d like to see if its possible to do this in house, as we have a calibration lab.
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
Electronics Forum | Wed Nov 02 16:36:05 EDT 2016 | ttheis
Problem was bad FCU board; replaced with FCU from another machine and swapped rom chips. Oven operates properly and communicates with PC. BTU was kind enough to supply the default usernames and passwords for wincon but they did not work. Still waiti
Electronics Forum | Mon Jun 03 16:52:22 EDT 2013 | smellew
Hi Yes, there is an FCU calibration procedure which may help you, for this information please contact us direct. Email llew@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com Fuji, DEK, BTU, Ersa & Vi Technical support & service
Electronics Forum | Fri Sep 16 16:22:51 EDT 2005 | JW
Sounds similar to a recent problem with our VIP70. We thought it may be the SSR, then the FCU ... Swapping blower unit with a second oven finally helped us traced the problem to the thermoswitch inside the blower assembly.
Electronics Forum | Wed Sep 15 17:14:05 EDT 2010 | jwentz
Seems we had similar issue years ago with our VIP 70. There are a series of 2pin axial fuses on the panel with the SS relays and contactors (I don't think it was over the FCU). Check each fuse with a meter; replaced ours and the e-stop cleared and th
Electronics Forum | Sat Dec 10 22:41:41 EST 2016 | ttheis
Hi Ray, BTU was not too helpful with me because we bought the machine second (probably third or fourth) hand. I bought some FCU's from Ed at Assured Technical Services (assuredtech@yahoo.com) and a hard drive that had the Wincon software we needed.
Electronics Forum | Fri Sep 16 06:34:07 EDT 2005 | ajay
We have link fail issue now & could not able to establish. Overall situstion is that oven can not work. we checked all relay 24vac, 24vdc, 110v, 120v, 240v. all looks ok. only issue we ovserve that from B250SSR pin no 3&4 we are unable to get 5VDC. T
Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
| 1 |
