Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Thu Sep 15 13:32:04 EDT 2005 | cyber_wolf
Does anyone have any experience with these ovens ? We are looking at purchasing a used one. Anything in particular I should look at when inspecting it ? Any comments good or bad appreciated..... Thnx, Sr.
Electronics Forum | Mon Apr 24 01:12:28 EDT 2006 | fastek
Sure...I can help. Reduce the temperature and the error will go away. Seriously though.....I'm not sure that oven is even capable of those temps. Is it even convection?
Electronics Forum | Mon Sep 19 13:24:05 EDT 2005 | cyber_wolf
OK guys here is the skinny..... We need an oven that can handle lead free temps without slowing the belt speed under 28 or so in. per min. BTU tells me that they don't recommend an oven that maxes any less than 350 C. Is anyone using a paragon 150
Electronics Forum | Mon Sep 19 17:21:14 EDT 2005 | rick
They're full of crap and are simply trying to get you into a Paramax 150. Depending on your product you could probably get by with a VIP-98.
Electronics Forum | Thu Sep 15 19:01:26 EDT 2005 | russ
I beleive what they are doing now for the blower issue is giving a lifetime warranty on them but they still haven't upgraded to prevent the frequent failures. Personally I prefer a warranty that I don't need.
Electronics Forum | Thu Sep 15 19:28:25 EDT 2005 | fastek
From a used equipment dealer's perspective I know they are always in high demand and are difficult to locate used. Them and Electrovert are the best.
Electronics Forum | Sun Apr 23 09:07:42 EDT 2006 | kanna
i have one problem here with BTU TRS-14. we encounter Over temperature Alarm trigger when run lead free product. our profiling peak temp is 230 degree's and the temperature set point at zone 4 top/bottom is 260 degree's. can any help on this issue
