Electronics Forum | Sat Jun 19 08:32:49 EDT 2010 | davef
Please describe the location and appearance of the crack
Electronics Forum | Mon Jun 21 12:02:36 EDT 2010 | roland_grenier
check your de-panelling process if you are using break-out tabs or V scoring.
Electronics Forum | Sun Jun 27 22:25:51 EDT 2010 | leadthree
*** silly question deleted, there are no 100nF NPO ***
Electronics Forum | Fri Jun 25 09:18:23 EDT 2010 | flipit
Thanks, Dennis. That is a good idea, but I > have problem :) - our logistic department lookig > for cheap components...What other mnfg of cap you > use? Regards, The capacitor dielectric material might be something you could look at also. COG,
Electronics Forum | Wed Feb 02 20:00:48 EST 2005 | davef
150*C/min * Determining the distance it takes to lower the delta temperature at the current conveyor speed: [150*C/min]/[25 inch/min] = 6*C/inch * Calculating how much of this 6*C/inch would be spread along the length of the 0805 capacitor: [6*C/inch
Electronics Forum | Fri Jun 25 05:34:40 EDT 2010 | ppcbs
Hi iv40 Try with NIC ceramic capacitor that was tested in wet process. We hav succeed with these cap after we found some failure with Kemet ceramic Cap which tested in dry test process while manufacturing.
Electronics Forum | Tue Apr 17 10:22:16 EDT 2001 | tom g
Has anyone out there had solder joint wetting issues with Murata ceramic chip caps, in particular with Alpha UP78 no-clean paste? We are finding that changing either the paste or the vendor corrects this problem. If so, please advise your solution(
Electronics Forum | Tue Apr 17 21:19:31 EDT 2001 | davef
Curious. Tell us more about: * Murata solderability protection * Solderability protection on the caps used to replace the Muratas * Reflow profile used with each of the two pastes * Differences in the two pastes
Electronics Forum | Wed Dec 17 12:48:15 EST 1997 | Mike Cox
I need information on how to interpret the markings on ceramic chip caps. IE: a3 = .01uf etc. Any info on a source would be great Mike Cox
Electronics Forum | Thu Dec 18 04:31:24 EST 1997 | Robert Cass
| I need information on how to interpret the markings on ceramic chip caps. IE: a3 = .01uf etc. | Any info on a source would be great | Mike Cox Check the supplier they should have laser marking tables A4, AE