Electronics Forum | Thu Jun 06 07:53:51 EDT 2002 | Jim M.
Has anyone had much luck Picking and Placing die with a Panasonic MPA-G3?What special setups or considerations are required? Currently we pick and place one die with our Universal GSM using only one nozzle. The nozzle must be painted white in order
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Wed Feb 24 10:57:52 EST 2021 | spoiltforchoice
And then they make a new machine, and start the software all over again, or change the hardware so much the older model doesn't get any of the software tweaks on the new one even if they are supposedly the same model.... Neoden bigger machines shoul
Electronics Forum | Tue Sep 10 08:01:47 EDT 2002 | mpotter
Kevin If you want to go automated then why not take a look at the Philips ACM. It is the flagship for placing SMT and Oddform packages. We use Vacuum nozzles and Grippers to handle many truly oddform components.
Electronics Forum | Tue Aug 20 07:35:04 EDT 2002 | bmulcahy
Hi, I guess you a looking for a manual x-y table with a vacuum pick up such as SMT6000 from OK industries. I presume these are still being made-- We use one successfully at the end of a Mydata machine to place low volume components which we cannot j
Electronics Forum | Wed Nov 24 06:24:52 EST 2004 | Joe
Hi, I am an Engineering student doing some research on the component/nozzle interface on SMT Pick and Place machines. Could anyone tell me the force at which the nozzle hits the component as it is picked from the feeder or the placement force on a
Electronics Forum | Fri Feb 16 11:07:25 EST 2007 | stepheniii
I'm not sure if anyone mentioned the single most important factor. p.m.'s. If the nozzles are getting dirty and clogged it's not going to do a great job of picking parts up. Don't think in terms of variation. It's there it's unavoidable and undet
Electronics Forum | Wed Nov 29 01:20:44 EST 2006 | fastek
Guess- If a component drops at the camera the machine will not proceed to attempt to place it and drive the nozzle into a brick of solder paste. The line sensor will catch the fact there is no component on the nozzle and will retry to pick and place.
Electronics Forum | Wed Nov 29 01:09:17 EST 2006 | Guess
I would suggest checking the feeder, MVF and MSR are both turret type and dont have the capability auto pik adjust in y. Y offset pick up would lead to : 1. Over turn component. 2. Missing component. Turret sequence is pick, recognize an
Electronics Forum | Tue Jan 08 14:41:08 EST 2019 | jrogalski88
I am a fairly new technician with a rather large electronics assembly company. Its been an ongoing issue to pick and place small coils using our Universal SMT machines. Curious if any if the seasoned techs at smt.net have any recommendations as far a
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694