Electronics Forum | Fri May 27 14:09:19 EDT 2022 | davef
No solder mask; Class 2 => Class T; Class 3 => Class H.
Electronics Forum | Mon Apr 13 18:18:31 EDT 2020 | wbrenner
Does any one have a general cost percent going from class 2 to class 3 for the same Assembly.. Or, general up charge percent when biding class 2 vs class 3?
Electronics Forum | Tue May 26 03:33:19 EDT 2009 | kevyeoh
May i know how do we differentiate between Class 1, 2 and 3 components? What are the key differences between those three classes? When i check at IPC document, it is stated that Class 1: General Electric Class 2: Dedicated Service Electronic prod
Electronics Forum | Thu Aug 07 22:51:05 EDT 2008 | davef
We expect aerospace to be IPC-A-610, Class 3 and J-STD-001, Class 3. The above quality statement stecifies: * "IPC 610, Class 2 acceptability." This is unclear. Should this be "IPC-A-610, Class 2 acceptability?" * No class for J-STD-001. Should we a
Electronics Forum | Thu Oct 05 07:43:22 EDT 2000 | Leon
Anyone know where I might find info on class 1 class 2 and class 3 solder joints.
Electronics Forum | Tue Apr 08 12:38:12 EDT 2003 | Denise
I'm looking for comparison data on MTBF for solder joints meeting IPC Class II vs Class III.
Electronics Forum | Tue Jan 06 06:56:26 EST 2015 | stivais
How about rework (touch-up) for Class 3? Some say that you are not allowed to rework anything for Class 3. Though I have not found any proof for this 'requirement' in the standards.
Electronics Forum | Sat Jan 10 09:04:47 EST 2015 | jandon
class 3 requires 100% barrel fill Class 3 requires 75% vertical fill of solder for component with less or more than 14 leads. Not 100% fill.
Electronics Forum | Thu Feb 05 14:30:29 EST 2015 | chsravan
Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?
Electronics Forum | Mon May 04 06:31:50 EDT 2020 | jandon
Are you capable of doing Class 3 products? Does the design, bare PCB board and assembly meet the requirements of Class 3?