Electronics Forum | Wed Aug 12 16:41:20 EDT 2009 | JWPlainview
Thanks for clearing that up, Dave. We've been getting a lot of inquiries citing both certifications. Just thought there might be a link between the two.
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Fri May 23 15:31:46 EDT 2003 | daanterstegge
Hi ChrisX, DPMO = number of defects per million opportunities. PPM (parts per million) is exactly the same, although the terminology is less clear about what it means. SPC(statistical process control) is a methodology based on statistical technique
Electronics Forum | Fri Jan 27 09:48:26 EST 2006 | patrickbruneel
GS UPS are exempt for 2 reasons: A. Lead in solders for servers, storage and storage array systems, network infrastructure equipment for switching, signaling, transmission as well as network management for telecommunications. B. The primary functi
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Sat Jun 06 09:53:59 EDT 1998 | Earl Moon
GEOMETRIC DIMENSIONING AND TOLERANCING (GDT) Using and applying GDT to printed circuitry and assemblies is very much like applying it to any other design for manufacturing (DFM) or design for assembly (DFA) requirement using concurrent engineering (C
Electronics Forum | Wed Nov 06 05:13:01 EST 2002 | Dreamsniper
Crystalline flux if it is really clear should not be a problem. We were using Amtech paste before and we have the same results. Sometimes we mistakenly see it as a dry joint because of the reflections from the lighting of our Metcal inspection system
Electronics Forum | Fri Jan 27 15:39:08 EST 2006 | GS
Thanks Patrick yes I feel better now, but allow me a comment: Reason A: your answer confirms my tough. In general could be accepted Reason B: your answer "The primary function of ups start when electricity is "off" so the equipment is clearly exem
Electronics Forum | Thu Apr 07 19:17:43 EDT 2022 | cbart
Good afternoon The ISI I was mentioning is interconnections solutions which is a division of Molex. a few years back we ran into a component end of life situation but had thousands of very high dollar bare boards in stock. the package was a BGA and w
