| https://www.eptac.com/faqs/ask-helena-leo/ask/conductor-strand-damage-in-ipc-a-610-rev-e
Conductor Strand Damage in IPC-A-610 Rev E - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/ask/conductor-strand-damage-in-ipc-a-610-rev-e/
Conductor Strand Damage in IPC-A-610 Rev E - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-User-Guide-801-1-07.pdf
Axial Component Lead Former CF-8 Axial Component Lead Former Operating Instructions Version 2.2 April 2, 2007 Copyright (C) 2007 GPD Global® All Rights Reserved GPD Global
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-User-Guide-801-1-07.pdf
Axial Component Lead Former CF-8 Axial Component Lead Former Operating Instructions Version 2.2 April 2, 2007 Copyright (C) 2007 GPD Global® All Rights Reserved GPD Global
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/products/2k-two-component-products-mixers?con=t&page=10
prevent material damage by dynamically mixing wide-ratio, syntactic, two-component materials at point of application. Dual-Action Dispensing Nordson ASYMTEK Nordson ASYMTEK's Dual-Action Dispensing enables dispensing of two fluids with a combination of jets and valves operating independently Series 400 Autovalve
| https://www.eptac.com/ask/will-i-damage-a-wire-in-board-if-it-is-bent-too-far/
Will I Damage a Wire-In-Board if it is Bent Too Far - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/soldertips/accept-or-reject-solder-contacting-component-bodies/
. The reason being is that if the solder does touch the body it will reduce or eliminate the stress relief characteristic of the leads, which can cause physical component damage and failures, either
| https://www.eptac.com/faqs/ask-helena-leo/ask/will-i-damage-a-wire-in-board-if-it-is-bent-too-far
Will I Damage a Wire-In-Board if it is Bent Too Far - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/sealant-equipment/products/two-component-2k-products-mixers?con=t&page=3
prevent material damage by dynamically mixing wide-ratio, syntactic, two-component materials at point of application. End Cap Molding Case Study Nordson SEALANT EQUIPMENT Pro-Meter A2K Nordson SEALANT EQUIPMENT Single Servo Drive
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-flow-near-through-hole-component-body
. If the solder does touch the body, it reduces or eliminates the stress relief for the lead which can cause component damage and create failures
