Electronics Forum | Thu Oct 20 17:59:39 EDT 2011 | davef
inspection arrow Brady and Shercon are two brand names. People like Digi-Key and All-Spec sell them
Electronics Forum | Thu Oct 20 19:18:22 EDT 2011 | eadthem
Something also to consider is, if you don't need to remove the mark, look in to a uniPOSCA paint markers (water based paint). For us we find the arrows take so much longer than the paint, just poping the cap and dotting the problem and moving on.
Electronics Forum | Fri Oct 21 11:30:56 EDT 2011 | remullis
Thanks I got some coming from BRADY. These will have to be removed. Anyone ever needing the part # its, BIA-RD 2.00 bucks a sheet.
Electronics Forum | Thu Mar 07 06:20:36 EST 2002 | HCC
Hi y'all, I know this could be sensitive information, but can I just start up a benchmarking sharing on the missing component rate in Fuji CP742 chipshooter? We've been seeing quite a few missing RLC components, and even some components that end up
Electronics Forum | Tue Feb 15 12:49:42 EST 2005 | O.Tarango
we are experiencing a lot of components mis-aligned , Can anyone suggest me some causes of this defect. regards
Electronics Forum | Thu Oct 20 12:24:07 EDT 2011 | remullis
Where can I purchase the small RED arrows for component defect flagging? I cant seem to find them anywhere. Thanks
Electronics Forum | Thu Jun 13 21:44:21 EDT 2002 | jkhiew
Hi all, * Defect : termial to terminal touching btw two melfs body that created short circuit. * Clearance : 0.8mm btw two melfs body. * Size melf : diameter=2.4mm to 2.7mm, length=4.8mm to 5.2mm * Stencil opening : "v" shaped to minimise component
Electronics Forum | Thu Aug 29 20:01:23 EDT 2002 | davef
Many people use the same spacing [and pad designs] as they use for primary side SMT. We don�t. DOWN STREAM SMT-TO-SMT SPACING: In addition to proper orientation, components cannot be immediately upstream of terminations that are to be soldered or b
Electronics Forum | Fri Dec 27 13:16:18 EST 2019 | slthomas
Can you describe the failure mode of the soldering defect, i.e., is it failing to meet the height requirement for a castellated termination due to not wetting of the component terminations, or not wetting the pads sufficiently, or....? We install a
Electronics Forum | Thu Jul 19 18:15:15 EDT 2012 | jil2000
We have a material that is been stick at cover tape, only 1 supplier is failing and only embossed tape packing is failing. A dark spots between tape and component are observed, we already bake material to se if is humidity, is not. We already apply