Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc
We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w
Electronics Forum | Tue Oct 01 11:48:01 EDT 2013 | bengt
Hi All. We have bought EKRA E4 screenprinter. We are running R to L and printer has L to R direction. Does anyone can help me on this ? On specs it says all kind of directions.
Electronics Forum | Wed Jan 18 08:34:09 EST 2006 | Nathan
We are designing a new in-line inpsection station for PCBAs and I am a little confused about how to interpret two the Mech. Interface standards in SMEMA 1.2 (items 5 and 6). What is exactly meant by "maximum gap"? Does this get at the distance betw
Electronics Forum | Tue Jun 23 12:21:51 EDT 1998 | Robert Cass
We have a need to manually insert, cut and clinch a radial part that is prep close to spec on a board traveling down a standard conveyor. Is anyone aware of such a system? I only know of regan off line.
Electronics Forum | Wed Jun 24 16:40:32 EDT 1998 | GERRYR
| We have a need to manually insert, cut and clinch a radial part that is prep close to spec on a board traveling down a standard conveyor. Is anyone aware of such a system? I only know of regan off line.
Electronics Forum | Fri Feb 14 21:57:35 EST 2003 | caldon
Hello All- As per IPC SMEMA Specs the max gap distance should be .375" This standard can be downloaded from IPC's website at http://www.ipc.org/html/fsresources.htm This Doc has a fair amount of useful info. Best Regards, Cal
Electronics Forum | Tue Jul 18 19:20:25 EDT 2006 | sharifudin
Actually we run lead free solder paste and the profile spec very tigh.I can't use capton tape due my product in panel form and save cost.I already verify conveyor,machine and tool free from dust and solder paste but the problem still remain.
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Fri Dec 16 11:04:23 EST 2005 | chunks
Over all time will be dictated by your conveyor speed. Your conveyor speed will be dictated by your products time above liquidous. Time above liquidous is dictated by the manufacturers specification. Time and temp before reflow will have to be ach
Electronics Forum | Wed Jun 24 16:44:27 EDT 1998 | Gerryr
| We have a need to manually insert, cut and clinch a radial part that is prep close to spec on a board traveling down a standard conveyor. Is anyone aware of such a system? I only know of regan off line. There is a system called a clinch master by
