Electronics Forum | Wed Sep 26 15:04:09 EDT 2012 | kahrpr
The QSA30 is basically a Samsung CP40 with a few changes. For an older machine the programming is pretty good. it can do array boards and has an import feature for XY data. Tts been about 7 years since I ran one. Its a pretty solid machine.
Electronics Forum | Thu Mar 02 14:04:30 EST 2006 | amol_kane
do u mean program as in software? Minitab can do all the basic statistical analysis for your data and give you Cp, Cpk Values. The Cp and Cpk values are derived from estimates from the data (hence necessary to have Confidence Intervals). Regards, Am
Electronics Forum | Tue Sep 30 21:08:17 EDT 2003 | George
I just start training as operator of a Samsung CP-11E Pick-and-Place machine. I would like to know where to find info or tutorials about those machines or general info about "how smt pick-and-place machines work ". I have not found anything on the we
Electronics Forum | Mon May 14 14:24:28 EDT 2012 | smellew
30x30 is ok for CP65 not CP6
Electronics Forum | Thu Nov 30 04:34:39 EST 2017 | robertorocco
Hi sarason The O.S. is win98 not win95. The repair function is chkdsk? Beacause the O.S. not start do you think the start chkdsk from DOS? Thanks Roberto
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Thu May 03 15:07:59 EDT 2012 | rodrigo
Hi all, What the largest part I can place with these machines? I'm going to try to install a PLCC68 using the front light because the part is bigger than the backdisk and I want to make sure it can handle it. The part is about 30mmx30mm. Thanks
Electronics Forum | Mon Jan 18 12:03:37 EST 2016 | rfm2nd
would anyone possibly have the calibration jigs to be used in calibrating the cp-45 and/or the cp-60 machines from Samsung?
Electronics Forum | Mon Jan 18 12:04:24 EST 2016 | rfm2nd
would anyone possibly have the calibration jigs to be used in calibrating the cp-45 and/or the cp-60 machines from Samsung?
Electronics Forum | Wed Dec 06 23:12:09 EST 2000 | Brad
Chris, Have you considered Fuji? The robustness of Fuji is proven. I have recently done floor space analysis and cost per placement/sqr foot studies. I have also performed ROI studies on these machines. The new CP7 machine from Fuji outperforms th