Electronics Forum | Sun Nov 05 11:52:41 EST 2006 | csm
Can somebody let me know if Sanyo TIM-1000 pick and place can mount BGA's? and qty dots per hour of TDM-1000. I will apreciate your importants comments Regards.
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Tue Jul 14 08:23:41 EDT 2009 | csm
Dear Jepoy I apreciatte your support, we will check and do all your recomendations an will let you know progress. Best Regards
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Mon Jul 11 18:56:59 EDT 2011 | csm
Dear All Can somebody recomend me a good Technician can train us in Phillips FCM 1 operation, maintenance, etc, we have 2 machines and want to make run, can be 2-3 Days only. Machines are in Mexicali BC Mexico, The Tech can be in California. Thank
Electronics Forum | Sun Jun 14 15:40:48 EDT 2015 | csm
Dear All We are looking some Phillips Technician can do programming for FCM-2 equipment and we are looking the Programming manuals and maintenance manuals. Can somebody help us, or can give us support to give maintenance and programming to some FCM
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Thu Nov 03 14:27:57 EDT 2016 | csm
Dear Tom I appreciate your feedback, we checked all you mentioning and are OK, yesterday we found one card is Not turning ON. We are checking harneses solders etc.
Electronics Forum | Thu Nov 03 14:33:40 EDT 2016 | csm
Dear JummyB We noted that when the machine is initializing, and when all check step pass, we just push ready button and the main relay or contactor must be activated but is not, it looks like one Card in front of the machine where all the drivers ar
