Electronics Forum | Wed Feb 09 11:33:36 EST 2005 | OverTheHill
It's been about 1 month since replacing the above parts, and no tool damage so far.
Electronics Forum | Fri Dec 08 09:48:11 EST 2006 | SMTRework
Hi Guys / Gals, just curious as to how some of you approch BGA pad damage? (ie broken or lifted pads) Also, what kind of success rate have you found with your method?
Electronics Forum | Wed Feb 09 11:51:45 EST 2005 | cyber_wolf
Cool. You are good to go !
Electronics Forum | Sat Nov 04 12:32:32 EST 2006 | grantp
Hi, Your dragging up a thread from back in 2004 here? Grant
Electronics Forum | Sat Dec 09 08:47:41 EST 2006 | davef
Look here: http://www.circuitrework.com/guides/4-0.shtml
Electronics Forum | Thu Dec 21 13:35:32 EST 2006 | ppcbs
Send it to the BGA Rework Specialists at: http://www.pcb-repair.com
Electronics Forum | Thu Dec 23 12:32:57 EST 2004 | OverTheHill
All right all you Mydata techies. Here's the scoop. My old TP9 seems to be damaging (bending) it's A12 and A13 tools way too frequently. Like 4 tools in the last month. It appears the tool is colliding with somthing. My perfect operators SWEAR there
Electronics Forum | Tue Jan 22 20:37:48 EST 2002 | davef
Try: * Searching the fine SMTnet Archives. We have ground profiling, thermocouple attach, etc. to pulps. * Buying [ http://www.ipc.org ] IPC-7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
Electronics Forum | Thu Dec 23 13:38:25 EST 2004 | clampron
Over The Hill, Sounds like you may have an incorrect height specified on a package causing the tool to slam into the board. The most likely cause is removing a magazine while the machine is running but I too have perfect operators who NEVER do that.
Electronics Forum | Tue Jan 04 22:41:47 EST 2005 | Dorklover664
Are you sure that the operators are checking pickup placement before the run starts? We had that happen once when yours truly didn't do her job right. Megan
