Electronics Forum | Thu Jun 22 11:24:04 EDT 2000 | Mike
What is your opinion on the current debate about lead in CRTs and not allowing them in landfills?
Electronics Forum | Tue Nov 23 07:42:47 EST 2004 | Alan
I was highly debating the purchase of Tecnomatix (Assembly Expert) software. However, went with Circuitcam for a few reasons. Call me at 248-994-3012 if you want details.
Electronics Forum | Mon Jul 26 21:28:49 EDT 2004 | KEN
May I ask why silver in your wave solder bath? This is an interesting debate of "silver or no-silver" at wave solder. Many thanks for your input.
Electronics Forum | Thu Aug 12 10:02:00 EDT 2004 | JB
There is a lot of debate over efficiency rates in our group, what percent would indicate that we have a good efficiency rate in our SMT production lines? Ours vary from 40- 60% We are constantly trying to improve this numbers, but I am curious as wer
Electronics Forum | Tue Sep 28 08:23:23 EDT 2004 | patrickbruneel
The lead free debates are getting more and more interesting Didn't know that low labor cost was also lowering melting temps of LF alloys
Electronics Forum | Thu Jul 07 16:54:41 EDT 2005 | Inds
Yup Pat, even I read that article.. would love to challange them..but can't.. i think the debate on whether to go lead-free or not.will continue ever and ever after.. WE can call it Lord of the Ring-Part 4 created by europeans..
Electronics Forum | Mon Apr 30 14:17:35 EDT 2007 | slthomas
My specific gripe is with the following statement: "Since the U.S., and thanks to Bush and his like,..." The debate as to why he's in this pickle could go on for a very long time and it doesn't have anything to do with resolving his problem.
Electronics Forum | Fri Feb 19 12:52:00 EST 2010 | dcell_1t
I have a debate here with Facilities maintenance dept. oven is asking for 550 SCFM and they are measuring 770CFM I know that is different SCFM to CFM... but I don't know the pressure. any thoughts on how to convert???
Electronics Forum | Thu Jun 08 18:29:36 EDT 2023 | emeto
Hello folks, is there a standard you follow for maximum cleaning cycles? We are debating how many times we should clean a board for misprints on the second manufacturing side? First side is already assembled and I wonder how many times we can safely
Electronics Forum | Fri Jun 02 09:31:26 EDT 2000 | C.K.
Okay, there's a debate here at my company. We build a card here that, often times, we get batches where there is excess HASL in the VIA hole barrels. Here is the problem that this causes: During the "1st reflow", the excess HASL bleeds out of the
