Electronics Forum | Wed Jun 26 13:42:14 EDT 2013 | nucleus
Hi, we just bought a used dek infinity 265. Unfortunately we cannot find a programming manual. We have two big technical references and a operator manual. Is there someone who has a pdf-version of the programming manual? Thanks! Best regards mts
Electronics Forum | Wed Jun 26 17:46:48 EDT 2013 | dman97
numeric values are input by pressing the / key.
Electronics Forum | Wed Jun 26 13:44:37 EDT 2013 | nucleus
by the way: How can I input numeric values by keyboard instead of pressing value +/- all the time? thanks!
Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Wed Sep 12 08:22:52 EDT 2001 | pr
Last I heard DEK was coming out with a new Revision of Form Flex to address some of the problems seen on the old revs. You should contact Dek and see if they will replace your old ones with the new rev. When ot works it's a great tool.
