Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Thu Oct 04 00:00:58 EDT 2018 | gaintstar
Flason SMT Reflow Ovens: http://www.flason-smt.com/product/China-Reflow-oven.html http://www.flason-smt.com/product/China-Samsung-EXCEN-PRO-High-Speed-SMT-Modular-Chip-Mounter-agent.html http://www.flason-smt.com/product/China-Samsung-SM321-High-Spe
Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
