Electronics Forum: dek clamps (Page 1 of 6)

dek 265 LT screen printer unable to detect the plate

Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead

If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st

Complete Squeegee Clamps with Blades - DEK248 Available

Electronics Forum | Thu Nov 14 11:37:49 EST 2019 | tcpds

Do you still have the dek248 squeegee clamps/blades? please direct email me at thart@prairiedigital.com

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead

>> mis-alignment?

Complete Squeegee Clamps with Blades - DEK248 Available

Electronics Forum | Wed Sep 04 12:02:03 EDT 2019 | spinn

Hi all, Just to add further information to this post. We have 10 inch (250mm)and 19 inch (480mm) Dek 248 complete printer squeegee clamps with blades. On the 250mm one blade has a very slight kink though shouldnt cause a problem. Offers welcome

DEK265 GSX chase clamp error

Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas

problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh

MPM UP2000 Hi-e

Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd

Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the

DEK265 GSX chase clamp error

Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas

screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st

MPM UP2000 Hi-e

Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba

You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas

correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead

I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)

  1 2 3 4 5 6 Next

dek clamps searches for Companies, Equipment, Machines, Suppliers & Information