Electronics Forum | Mon Aug 21 10:08:31 EDT 2017 | vincent1991
hi guys. i looking for to reduce the cycle time as much as possible. but i dont want to increase the the fault or misalignment so i need to know the best delay time for pickup delay & place delay for smd package or part . i need your help & experien
Electronics Forum | Thu Aug 24 07:40:32 EDT 2017 | stephendo
Doing regular maintenance will usually make a bigger difference than reducing delay time.
Electronics Forum | Wed Aug 23 02:09:48 EDT 2017 | vincent1991
hi dear i must say the machine has optimized but i want to reduce the time . i want but i afraid to reduce delay to make defect part or machine dump it . so i need the best peak & place delay time for all component .
Electronics Forum | Thu Aug 24 18:28:41 EDT 2017 | tey422
dwl is right. You just have to spend some time to play with all the ones that causing the most delay. I would say the timing for X & Y axis try to set to max speed first (as long as not drops before placing). Then, slowly increase the Z speed until
Electronics Forum | Wed Aug 23 09:27:41 EDT 2017 | dleeper
As Evtimov mentioned, it will be dependent on package. It will also be dependent on the specifics of your machines so there is no universal "good" value. You will need to experiment to find the best values for your equipment and components. I would
Electronics Forum | Mon Aug 21 12:13:43 EDT 2017 | emeto
Will be based on package. For passive parts I will try with 0sec. For part that you see problems picking up or placing, you should start increase these until you get it right.
Electronics Forum | Mon Aug 21 13:21:42 EDT 2017 | tombstonesmt
Is this really where you are losing most of your time? Make sure your machine is optimized ie gang pickup, multiple feeders, feeder placement, etc..
Electronics Forum | Thu Aug 31 02:02:58 EDT 2017 | hxamalia
Hello ALL Good day , it is Amalia from HX Circuit Technology Co.,Ltd in China, we are a prefessional PCB factory with many years. We are focusing on quick lead time for PCB with good service . please contact with me now ,thanks Email: amalia@hx-
Electronics Forum | Wed Apr 26 09:18:19 EDT 2017 | dentata911
Hello Is it possible to make really big placement delay on this maschine? 3-4 seconds? Thank you.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
