Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao
There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total
Electronics Forum | Thu Apr 05 08:44:45 EDT 2007 | ck_the_flip
"Guest" is right, actually. CSP's are essentially BGA's, but typically the pitch and ball diameters are much smaller and in some cases, the pads of the CSP's can not be screen printed. If that's the case, you'd have to have flux-dip capabilities on
Electronics Forum | Fri Apr 06 08:45:48 EDT 2007 | davef
UNDERFILL The design of the component and the end-use environment drive the requirement fot underfill. Here is a good introduction: http://www.asymtek.com/news/articles/2002_globaltronics_csp_and_fcuf.pdf Google for more. We have no relationship, n
Electronics Forum | Fri Apr 06 01:10:16 EDT 2007 | Haris
My SMT line does not has these facilities so would you please tell me regarding the UNDERFILL AND FLUX-DIP process and how they can be done? Thanks.
Electronics Forum | Thu Jul 06 12:26:55 EDT 2006 | Chunks
Sounds like your flux to me. Since you cannot change the board or the machine, changing flux would be one question mark you could take away with a phone call and a sample. You will really be surprised how different fluxes can affect your final prod
Electronics Forum | Thu Nov 17 03:34:51 EST 2005 | cangly
Hi, We have a board with over 100 chips (mixed size) and some long Connector DIP through out Wave solder with many issues of no solder and solder bridge, (using clean flux with bubble fluxer and Kester solder bar). Currently we tried to reduce the de
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Wed Nov 29 01:20:44 EST 2006 | fastek
Guess- If a component drops at the camera the machine will not proceed to attempt to place it and drive the nozzle into a brick of solder paste. The line sensor will catch the fact there is no component on the nozzle and will retry to pick and place.
Electronics Forum | Fri Sep 06 14:07:20 EDT 2002 | ppwlee
Thanks for all replying to my printing SPC posting. I like to expand the SPC discussion on reflow and wave soldering. I am aware of the common methods of applying periodic measurements using test vehicles though the machines to collect critical pr
.gif)
