Electronics Forum | Wed Aug 05 11:04:33 EDT 2020 | ehess
What is the proper way to discard scrapped pcb's, pcba's and potted pcba's?
Electronics Forum | Fri May 02 14:11:13 EDT 2014 | comandorobles176
We recived a used IP3 and don't have NG parts conveyor and I want to set the proper to discard component only in ng parts discard box.I think is in "Machine_ID" but I don't know how, we have Fuji Flexa sofware. any help?
Electronics Forum | Fri May 02 15:56:41 EDT 2014 | jimmyboz
Give me 30 minutes.
Electronics Forum | Wed Aug 05 14:22:10 EDT 2020 | ehess
THANK YOU. ANY INPUT ON POTTED PCBA'S
Electronics Forum | Thu Jan 30 07:27:00 EST 2003 | cnotebaert
As said earlier the best way is to cure it then discard. Is your material heat cure or moisture cure? If heat cured and you ahve a oven place the material in trays and heat cure and discard. If moisture cure leave the material in the container and ad
Electronics Forum | Fri May 02 16:23:06 EDT 2014 | jimmyboz
Bits 0-3, no, Bit 4, MFU2 with error parts conveyor for camera 12, Bit 5,MFU1 with error parts conveyor for camera 12. The other guy is also correct, where to discard a component is in the part data. Still checking, please reply quickly if you solve
Electronics Forum | Mon Nov 07 06:16:59 EST 2005 | laxman
Hi, We have faced the solderability issue (Dewetting and solder balls)in all the Boards after reflow.When we found this issue we discarded the old paste and started using the new paste then for some hours the solderability found to be O.K. After so
Electronics Forum | Thu Jan 05 17:06:38 EST 2006 | russ
Is it now acceptable to discard the SAC alloy directly into the trash or is it still a requirement to dispose of through hazmat procedures. Seems to me that we can now just chuck the old paste right into the normal trash since it is the replacement
Electronics Forum | Thu Dec 09 19:18:00 EST 2010 | tpappano
I just take a piece of discarded cover tape and tie the two together with a square knot. It runs right through on my CSM84s
Electronics Forum | Fri May 02 15:39:55 EDT 2014 | taiji
its being a while since I used the Flexa, but I remember there was an option for reject position where you can change from box to conveyor, but not sure if it was on the part or shape library, not on the machine_id.
