Electronics Forum | Mon Nov 09 16:55:33 EST 1998 | Doug Clement
I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available?
Electronics Forum | Tue Nov 10 12:47:06 EST 1998 | Dave F
| I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | Doug: Fisnar m
Electronics Forum | Wed Nov 11 08:37:46 EST 1998 | Wayne Bracy
| I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | Doug: You mig
Electronics Forum | Thu Nov 12 10:05:05 EST 1998 | Doug Clement
| | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | Doug: Fi
Electronics Forum | Thu Nov 12 11:16:55 EST 1998 | Dave F
| | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | Dou
Electronics Forum | Fri Nov 13 10:25:11 EST 1998 | Doug Clement
| | | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | |
Electronics Forum | Tue Dec 30 10:27:49 EST 2014 | Anon
So far I know of two dispensing system cleaner and conditioner to purge the solder paste out to preserve the valve. Valve Purge from EFD Nordson and Purgel from Interflux. Are there any other alternatives for purging and cleaning dispensing systems?
Electronics Forum | Fri May 02 09:35:20 EDT 2008 | toddl
Hi everyone, I am looking for positive and negative feedback on the use of the paste dispensing system on MPM screen printers. We currently have four machines with this capability that we do not use. Our printer operators insist that the dispensing s
Electronics Forum | Wed Jul 20 10:27:40 EDT 2005 | CEB
Have you taken a look at PVA, they have very good dispensing systems as well.
Electronics Forum | Wed Nov 23 12:34:35 EST 2005 | PWH
Cartridges/dispenser systems supply even paste volume to the screen. This will help provide the most consistent squeegee roll as well as paste deposition on PCB. Messier, though = much printer maintenance. Some people also like to use a caulking g
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
.gif)
