Electronics Forum: double and inspection and work and station (Page 1 of 1)

Re: BGA rework station and x-ray inspector

Electronics Forum | Wed Jul 22 13:57:03 EDT 1998 | bill

We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. Thx for any information Best Regards, Stoney Tsai If you are doing any reballing

Re: uBGA rework and X-Ray inspection

Electronics Forum | Sun Apr 16 14:37:25 EDT 2000 | Roberto Navarro

Hi, I work for Nortel and here rework BGA'S we use DRS22 rework station and CRT 2000 X-ray inspection. The main problem is put again the BGA on the PCB because you need reboling the PCB and you could damage the soldermask. Talking about Air-vac is ve

Inspection and splicing

Electronics Forum | Thu Apr 05 18:18:56 EDT 2007 | coop

We get our splice tape through splicetronic solutions, I recomend the double splice tape. steir also makes the double splice tape it works good for attaching strips together and also for putting leaders on the tape, if your feeders require. GOOD LUC

Foam fluxer maintenance, storage and cleaning

Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef

Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept

Re: Visual Inspection after SMD Placement and After Wave Solder

Electronics Forum | Thu Jul 15 10:28:49 EDT 1999 | Boca

I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspecti

Re: Visual Inspection after SMD Placement and After Wave Solder

Electronics Forum | Thu Jul 15 16:07:39 EDT 1999 | Doug

I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspec

Need low cost pick and place machine for limited production

Electronics Forum | Mon Aug 10 15:15:17 EDT 2009 | indity

I have very little knowledge of pick and place machines or assembly, and was hoping someone could give me some advice of where to start looking. I do learn quickly so I am not afraid of challenges or learning through mistakes. I need to produce abou

  1  

double and inspection and work and station searches for Companies, Equipment, Machines, Suppliers & Information

High Throughput Reflow Oven

High Speed Precision In-Line SPI System - Mirtec MS-11
best reflow oven

Inspection mirrors for electronic rework and repair.
RETROFIT for More Effective Dispensing

Best Reflow Oven
NPM D3 Machine

MSD Dry Cabinets
Green Monster Stencil Wiping Rolls

500+ original new CF081CR CN081CR FEEDER in stock