751 double reflow consideration results

Electronics Forum: double reflow consideration (Page 1 of 76)

double side reflow soldering

Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch

Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to

Re: double sided reflow

Electronics Forum | Thu Jun 22 11:02:13 EDT 2000 | Chrys Shea

Jason, Double sided reflow should be no problem. People have been doing it for years. The surface tension of the molten solder will hold the components on the bottom side during your second pass. This is almost always the case, unless you have re

Re: double sided reflow

Electronics Forum | Thu Jun 22 11:01:54 EDT 2000 | Chrys Shea

double reflow

Electronics Forum | Tue Feb 09 11:23:25 EST 1999 | michele sommaruga

I would like to have information about the processability of different packages. In particular I would like to known for which package I can use a double reflow for soldering. Best Regards

Re: double reflow

Electronics Forum | Tue Feb 09 13:07:00 EST 1999 | ETS - Brian Stumm

By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | I would like to have information about the processability of different packages. | In particular I would like to known for which package I can use

Re: double reflow

Electronics Forum | Wed Feb 10 07:50:52 EST 1999 | michele sommaruga

I am referring to reflowing twice. Fist time I reflow the up side, turn the PCB and reflow the bottom side. | By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | | | | I would like to have informat

Re: double sided reflow

Electronics Forum | Tue Jun 13 21:53:31 EDT 2000 | Dave F

This site is dedicated to double sided reflow and solder balls. Wasssup?

double sided reflow

Electronics Forum | Tue Jun 13 21:18:02 EDT 2000 | sachi

is there a site or any information available for double sided reflow? Our compnay is rather new to this proceess and before we get deep i'd like to know more about it.