Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Mon May 14 09:43:37 EDT 2001 | orbotech
As the face of business changes through revolutionary factors, such as the increasing rate of outsourcing, manufacturers (especially EMS plants) will strive to fine tune their test strategies to ultimately improve and sustain product quality and to r
Electronics Forum | Fri Sep 02 19:31:40 EDT 2011 | jlawson
I agree that if information is processed correctly up front in process down stream QA becomes less expensive ie AOI etc as AOI at end of lines is telling you you have made mistakes in up stream. I better to eliminate mistakes or have process to avoid
Electronics Forum | Sat Jul 22 13:20:35 EDT 2023 | shrikant_borkar
Dear Abhishek, I too got the opportunity to investigate this defect Lift lead for SOT. Lead lift in IC, and SOT can occur due to various reasons. Here are some possible reasons for lead lift and ways to avoid them: During the assembly process, mecha
Electronics Forum | Tue Aug 01 20:50:03 EDT 2023 | calebcsmt
If it was only 1 or 2 components on a reel that were backwards, I would lean more likely the cause just being the component was wrong direction in Tape from factory. Not much you can do from a Pick & Place perspective, generally.. Most machines use
Electronics Forum | Thu Apr 27 05:45:20 EDT 2017 | pavel_murtishev
methos1979, 1. Mirtec, Marantz 2. Koh Young, Orbotech, Mirtec 3. Koh Young Zenith 4. Definitely Programs for 3D AOI are prepared really faster. Having defined component database, programming takes no more than a couple of hours. Fine tuning takes u
Electronics Forum | Thu Apr 27 08:42:22 EDT 2017 | pvasquez
Hello M. We are a low volume high mix manufacturer with a total of 7 Mirtec AOI machines including a new MV-6 OMNI 3D system. I am very pleased with this machine! When we did our 3D AOI research, my team narrowed the field down to 2 vendors, Mirt
Electronics Forum | Fri Apr 28 10:12:55 EDT 2017 | clampron
Hello M, I have been a Mirtec user for quite few years (not dating myself). I had started with the MV-2 system and sequentially upgraded to the MV-3 and now the MV-6 Omni. We had tremendous luck with the MV-3 from a programming and defect detection
Electronics Forum | Tue Jun 30 11:12:58 EDT 2020 | dontfeedphils
AOI cycle times typically increase as defects/false calls found increases. If it's not that then possibly aging hardware or something has become corrupt in the software?
Electronics Forum | Tue Jun 30 18:07:34 EDT 2020 | daisy_mu
Hi Phill Thank you, It´s a possibility because that model has many false calls and real defects, but only in one component. A while back we had a similar problem and we changed the component number to a new one, and the cycle time was better, but th
