Electronics Forum | Tue Feb 21 07:58:35 EST 2006 | Aaj
Comparing KIC and ECD Gold mole profilers, which one is easier to buy batteries for? and why?
Electronics Forum | Thu Aug 02 12:43:14 EDT 2001 | nwyatt
Wave rider is an oven profiler made by ECD. http://www.ecd.com. They are commonly known for their MOLE. The wave rider is different from the MOLE because it is used to measure the temperature, conveyor speed, etc. of the OVEN instead of the pcb.
Electronics Forum | Mon Aug 16 11:20:09 EDT 2004 | soease
Hi, to profile any type of temperature process, you should try ECD products. I'm used to work with their tool called Super M.O.L.E. Gold, wich is a data logger for six thermocouples that you can run through a reflow oven, for example, and then you c
Electronics Forum | Fri Nov 20 12:41:41 EST 2009 | brycearkos
Has anyone attempted to, or successfully used a custom made (DIY) protective thermal enclosure for the Super M.O.L.E. gold profiler? We recently purchased a Bravo oven that came with everything for the ECD profiling system... except for the thermal
Electronics Forum | Wed Jul 31 10:03:44 EDT 2002 | gdstanton
Todd, Slim KIC 2000 would be my choice. We traded our Gold M.O.L.E for it and are very happy with the performance. The optimization program is great. No more guessing. The only thing I could gripe about is that it sucks up 9V batteries pretty quic
Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.
Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Wed Sep 05 14:51:47 EDT 2001 | gdstanton
Well, it appears after running both a bare and populated PWB we were seeing flux exhaustion on the uBGA. The problem apparently resulted by a recent maintenance effort where the air blowers in the reflow oven were replaced. The blower replacement m
Electronics Forum | Wed May 12 08:16:33 EDT 2004 | solderpro
woow, slow down hot rod, hey davef, you are alright by me, good to see some one out there that has hands on experience rather than a theory nut.... any how, you need a top of the line profiler, super gold mole, or Kic.... these truly are the best and
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
