Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Thu Jan 25 15:39:07 EST 2007 | electrovert
We swapped the solid state relay for zone 5 bottom to zone 5 top but the problem came up once a while. As for noise protection, there are jumpers at E1 to E8 and E9 to E16. They are hardware filters and prevent noise spikes from affecting thermocoupl
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Wed Feb 09 10:19:19 EST 2005 | pjc
According to one of Electrovert's reflow engineers, hour meters have not been installed "for quite some time". So, I stand corrected, older OmniFlo series ovens may have hour meters.
Electronics Forum | Wed Jan 20 18:57:06 EST 2021 | echanelo
Hello, I'm in desperate need of a boot up disk for my Electrovert Omniflo 5 oven. Type: OMNI 5SE Date: 5/98 I would like to purchase or borrow. Or maybe someone can point me the right direction it would be greatly appreciated. Thanks
Electronics Forum | Mon Jan 24 14:26:32 EST 2005 | pjc
Nope, no hour meters on Electrovert OmniFlo series ovens. I concur with Fastek's comments. Never buy a machine without performing a physical inspection. Post question like: What should I look for in an inspection of an OmniFlo oven? First off, it mus
Electronics Forum | Fri Nov 02 14:22:20 EDT 2012 | marcelll
Hi, I'm looking for a copy of the Omniflo oven firmware. I'm talking about the model running under Win NT. Oven vintage is 1999-2001. Our oven is a 7 zones but I thing there's only one firmware for all the Omniflo ( 7, 10 12 zones . The original was
Electronics Forum | Wed Jan 19 14:43:51 EST 2011 | davidalvarez
Im looking for manuals + schematics and repair information for an electrovert omniflo 7e reflow oven manufactured in 1999, also intrested in the Bill Of Materials if available. Any information on where these can be obtained and where replacement part