ii-Feed is based on the strengths of Europlacer’s proven concept of a cart plus elements but incorporates key aspects of our individual feeder technology, merging the best of both technologies. Each individual ii-Feed element is fully intelligent, p
Electronics Forum | Thu Sep 09 07:56:28 EDT 2004 | mksslcheng
A fresher goes in SMTonline ,I would like to learn the knowledge that how to embed and high temp. solder thermocouple into PTH hole while profiling board ,where the bead of T.C be located ,whether in PTH hole or protrude the bottom surface of board .
Electronics Forum | Tue Sep 14 08:16:37 EDT 2004 | davef
Try: 7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
SELL MPAG3 MSF 8MM Embosed Feeder,Low Cost
Industry News | 2012-10-24 16:58:28.0
Europlacer, announces that it has further strengthened its solutions with the launch of a new evolution of its tape feeding solution
Industry News | 2012-11-27 15:24:14.0
IPC’s National Conference on Electronics Design, Assembly and Reliability (NCEDAR), to be held December 4–6, 2012, at the Indian Institute of Science in Bangalore, India, will provide information on state-of-the-art technologies in printed circuit board design and manufacturing.
CM402/602/NPM Feeder CM402/602 8mm Feeder 0201 N610031080AA CM402/602 8mm Feeder with sensor KXFW1KS5A00 CM402/602 8mm Feeder without sensor KXFW1KSBA00 CM402/602 12/16mm Feeder with sensor KXFW1KS6A00 CM402/602 12/16mm Feeder witho
GAK-1208/E300 Sony 12x8mm Emboss feeder Model: GAK-1208/E300 The below Sony feeders are ready to ship, please let us know if you need. Thank a lot! GAK0802/P100, GAK0802/E100, GAK0804/P100, GAK0804/E100, GAK1204/E100, GAK1208/E10
Technical Library | 2012-06-07 21:44:28.0
First published in the 2012 IPC APEX EXPO technical conference proceedings. IPC-175x Intent: To establish a standard data exchange format that will facilitate, improve, and secure data transfer between all members of a supply chain.
Technical Library | 2016-12-15 17:18:28.0
Why embed the components? Embedded components have advantages over SMD because they are naturally screened from high frequency radio emissions (RFI or EMI). They can also be smaller than current SMD components. Both embedded and Mulpin components have these advantages, but Mulpin components have many more advantages and none of the disadvantages which can be seen below.
ii-Feed is based on the strengths of Europlacer's proven concept of a cart plus elements but incorporates key aspects of our individual feeder technology, merging the best of both technologies. http://www.europlacer.com/en/ii-feed.html
00375200-01 Retrof.kit Discharge Choke Coil, HS50-60 00375245-01 SPARE PART KIT X-DRIVE FOR HF UNTIL S-NR. 00375273-01 Cable abrasion protection foil 00375274-01 Cable abrasion protection foil 00375276-01 Cable abrasion protection foil 300mm 003
SMTnet Express, December 15, 2016, Subscribers: 29,169, Companies: 15,034, Users: 41,584 A Comparison of Mulpin VS Embedded Passive Technology Mulpin Research Laboratories Why embed the components? Embedded components have advantages over SMD