Electronics Forum | Tue Jan 09 06:45:08 EST 2018 | micomac
We have Europlacer flexys pick and place. We have had 3 turret collisions with 8mm feeders arising from the tape retaining clip coming free during operation. Have asked Europlacer for part numbers for safety catches that a technician told me existe
Electronics Forum | Wed Nov 24 11:06:50 EST 2004 | ccleland
You might want to look into one of the machines from Europlacer or Mydata that have very high feeder capacities(200 or more) and intelligent feeders. They were designed for minimal change over time in high mix environments.
Electronics Forum | Wed Mar 19 18:40:03 EDT 2014 | guts1872
We use IQ feeders from PPM and cant find any reference material on maintenance and calibration of these feeders. Does anyone here know where I can get repair manuals, diagrams, or any info on these feeders at all?
Electronics Forum | Thu Mar 20 14:58:04 EDT 2014 | aybars
We use IQ feeders from PPM and cant find any > reference material on maintenance and calibration > of these feeders. Does anyone here know where I > can get repair manuals, diagrams, or any info on > these feeders at all? Hi guts1782, IQ feed
Electronics Forum | Tue Dec 22 17:32:17 EST 2020 | atpico
We are looking to buy a 2nd hand Europlacer p-n-p. We would be very grateful to have a real production competent opinion about EP feeders/trolleys Questions: 1. generally how good/bad are older (Gen1, Gen2) Europlacer feeders and trolleys systems
Electronics Forum | Wed Dec 30 13:26:55 EST 2020 | atpico
Hello Dave, Thank you. I certainly look on Used Equipment Mart section. The question was if Gen 1 feeders/trolleys worth to invest or better try to buy EP Gen 2 feeders/trolleys even if significantly much expensier/rare on used machines market.
Electronics Forum | Tue Jan 05 07:31:34 EST 2021 | atpico
Great! Thank you! What about Gen1 vs Gen2(NT) EP feeders (not feeder elements)
Electronics Forum | Tue Jul 19 12:36:03 EDT 2016 | jbuckley
My company uses both Juki electric and mechanical feeders. Yes, electric feeders are much more efficient than mechanical as far as pick speed and general feed speed. However, if a reel runs out, it usually takes our operators under a minute to change
Electronics Forum | Thu Jul 28 10:42:25 EDT 2016 | mnorthey
We use the Juki electric feeders, I have not seen the mechanical ones. The reel holder is the only problem we have had with these feeders(cheaply built). That said our operators are trained to change a feeder in less than one minute, (originally it w
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim