Electronics Forum | Sun Feb 13 14:22:17 EST 2005 | griinder
Has anyone ever ran into a 20mm pitch on a 24mm tape and reel. Our software doesnt have a setting for 20mm. we found a way around it, but i was curious as to how common this pitch is, and if other software or feeders have a 20mm setting.
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Tue Feb 15 07:07:58 EST 2005 | bobpan
The mirae machine does have the setting for 20mm pitch....it can be set on the machine software but i dont believe its on the offline software.. thanks
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Mon Feb 14 13:25:52 EST 2005 | gregp
EIA-481 standard allows the maximum pitch on tape to be 4mm less than the tape width (12mm width and larger). So it is within the standard allowances. As for how common 20mm pitch on 24mm tape is I can not say. I am surprised a 24mm tape feeder ca
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Thu Apr 22 05:16:44 EDT 1999 | Ross Clunie
To save me re-inventing the wheel can anybody tell me an average no of pick-ups that can be expected from a Panasonic MV feeder before Feeder TPM should be carried out. Thankyou.
Electronics Forum | Thu Jan 31 07:55:04 EST 2008 | tonyamenson
I noticed on the floor that workers hand place some SMT parts becuase some parts that came in a tube (instead of on a reel) do not fit properly into the tube feeders. The tubes dont align properly in the feeders becuase of their size. Are there any
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Fri Jan 13 09:48:27 EST 2017 | westshoredesign
10mins to print an 8mm wheel. Experimenting with both Ninja Flex, and Ninja Semi-Flex, I think the Flex is probably going to be the winner though. Had to upgrade our filament feeder on the printer to use either of them. Totally worth it though. Not s
