Electronics Forum | Wed Jun 17 19:44:31 EDT 1998 | Eldon Sanders
Rob, I think the change over on the Quad QSP2 is about as easy and fast as it can get without swapping out the feeder bases. In a high mix environment I think it is worth looking at. Regards,
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Wed Jun 19 10:49:00 EDT 2019 | jamesn
Thanks Bob for the speedy reply I will check these out and let you know Kind Regards James
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Mon Oct 09 08:22:10 EDT 2017 | joycehughes
Thank you - we will follow your directions.
Electronics Forum | Fri Oct 06 16:49:28 EDT 2017 | joycehughes
In order to ensure that the machine arrives undamaged; what do we need to do?
Electronics Forum | Sat Oct 07 10:50:06 EDT 2017 | joycehughes
Many Thanks
Electronics Forum | Sat Oct 07 10:16:00 EDT 2017 | tsvetan
1. Secure all linear bearings to not move during the transport 2. Wrap the machine completely with stretch folio to protect from dust and moisture 3. Attach shock sensor to it so when it arrive you can see if it was subject to harsh transport
Electronics Forum | Sun Oct 30 18:15:18 EST 2005 | erokc
I'm looking at a Quad 1000 to purchase. Good machine? Does it do fine pitch? What should I check for before buying? I have feeders for Quad 100, will they work? Dave
Electronics Forum | Tue Nov 15 15:03:40 EST 2005 | lgroves
I couldn't resist, Under 20k used, uses quad feeders pretty accurate and relable - QSA-30?
