Electronics Forum | Mon Aug 06 14:12:49 EDT 2018 | tey422
I just found out we are unable to epoxy it. As the customer need to pull it up and open to tune the product. Which means the only way to solve it is by fine tune the pad and/or stencil design.
Electronics Forum | Tue Jan 22 22:23:48 EST 2008 | amarpreet41
Thanks, I am working on to prevent solder bridging. Tried fine tuning reflow profile, solder printing looks fine. Any further ideas??
Electronics Forum | Mon Jul 27 20:35:13 EDT 2009 | michaellaw
This is the common problem for RH6 m/c.You need to check of the following: 1)Make sure the spiral corl is secure properly especially near to detection amplifier box 2)you may try to fine tuning the sensibility VR on the detection card. 3)change the t
Electronics Forum | Thu Dec 09 12:23:07 EST 2010 | atiya124
Can someone tell me in detail How to fine tune the Gullwing when you create a program for 5 DX X-ray machine.
Electronics Forum | Tue Feb 25 06:52:56 EST 2020 | dontfeedphils
FYI, in my experience, programming and fine tuning select solder is usually quick and painless.
Electronics Forum | Mon Mar 20 21:46:31 EDT 2023 | emeto
The experimental way is the best approach for SPI settings and fine tuning. Have a start point of +/- 20%. You build 0402s and machine flags them 35% offset from value. You reflow, perform AOI - everything is fine. You go back and you move tolerance
Electronics Forum | Mon Sep 27 10:49:51 EDT 2004 | marc
Gary Getting the specs for a used machine will be tough from Ersa but at least send them a note, the seller should also be able to get the info for you. In regards a 5 zone system. I would suggest at least 7+ zones if your moving to lead free.
Electronics Forum | Tue Dec 20 10:10:21 EST 2005 | SteveH
Ours is the same configuration as that, we run with neat Humiseal 1B31 through the needle valve and a 1:1 blend 1B31/Butanone (MEK) in the spray valves. Programming is done via a PC using the pendant and the path is point to point trained on scrap P
Electronics Forum | Tue Jan 09 22:33:45 EST 2007 | Guest
Dear AJ, Try removing shield ,test it, verify if it would perform as the previous runs . If not, there maybe something wrong with device or as one of our collegue mentioned that there is possibilty the your customer change some components.If the
Electronics Forum | Mon May 17 16:09:03 EDT 2010 | davemacnemo
Is there anyone out there still using TDK RX11s and interested in sharing experience with a guy that has the dubious distinction of owning 2 of the beasts. They have great potential but stoppages due to parts inspection errors are killing me. Not a
