Electronics Forum | Tue Apr 27 07:20:34 EDT 1999 | Richard Marks
I'm a mechanical engineer and we buy electronic pressure sensors and switches. In doing quality audits, I need to understand what "best practice" will yield in terms of conforming product first time through the manufacturing process? Any data out t
Electronics Forum | Tue Apr 27 09:31:45 EDT 1999 | Robert L. McCallum
On circuit board assemblies first pass yields need to be above 98%, if a supplier is below this level it is a indication that: he has poor control of the manufacturing process; Poor component selection (price over quality; excepted a poor design from
Electronics Forum | Thu Jun 04 11:23:44 EDT 1998 | Frank S
If you could measure and chart 3 variables in my process, what would they be? The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure 7"
Electronics Forum | Thu Jun 04 11:57:59 EDT 1998 | Pete M
Be more specific on your problems? | If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. The
Electronics Forum | Thu Jun 04 15:02:38 EDT 1998 | M. Faisal Pandit
Frank, A couple of suggestions: 1. You may consider investing in a SPC Software package which would allow you to do a detailed analysis of your process. Panasonic's CIM Software Product, PanaPRO, has a well defined SPC application that can be used fo
Electronics Forum | Fri Jun 05 13:06:14 EDT 1998 | Steve Schrader
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Thu Jun 04 15:41:07 EDT 1998 | Chrys
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Thu Jun 04 12:26:30 EDT 1998 | Dave F
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Wed Dec 19 15:32:03 EST 2007 | slthomas
"Any risks associated with double pass stencil printing?" Mostly just too much paste, plus the associated bridging, and your stencil gets dirty quickly. Any gap between the stencil and the board gets filled with paste on the first pass, then migrate
Electronics Forum | Thu Dec 20 10:15:09 EST 2007 | slthomas
Wow, Chunks, condescension becomes you. Not. I think that in this forum when someone mentions *stencil* printing and doesn't specify what material, we tend to gravitate towards a scenario that involves printing solder paste first, then adhesive. If
